Material Used For Knuckle Joint
Material Used For Knuckle Joint. Knuckle joint is used for connecting two rods whose axes either coincide or intersect and lies in one plane only. Due to the low weight of this.
It has been found that knuckle joints made of aluminum have the highest safety factor of. The knuckle joint is analyzed for structural steel, aluminum alloy, cast iron. Knuckle joint, all parts like fork end, knuckle pin, taper pin, collar and eye end used material is steel and wrought iron.
It Was Mentioned That Torsional Overload Of The Knuckle Joint Is The Major Cause Of Failure.
The taper varies from 1 in 48 to 1 in 24 and it may be increased up to 1 in 8, if a locking device is provided. Good proportions for steel knuckle joints without bearings, good proportions are as follows: Stainless steel, structural steel, aluminum, magnesium, and ;
It May Be Noted That All The Parts Should Be Made Of The Same Material I.e.
Iron (ductile iron), white cast iron, and grey cast iron. Developedin knuckle joint made of magnesium alloy is 170.6 mpa which is the lowest among considered materials and maximum stress developed in knuckle joint made of gray cast iron is 176.77 mpa which is the highest among considered materials. Materials use in knuckle joint parts knuckle joints can be made from various materials like aluminum, stainless steel, structural steel , magnesium, and gray cast iron have been studied and it was found that knuckle joints made of aluminum have the highest factor of safety for 50 kn loading condition.
Diameter D = Rod Diameter Fork:
[3] studied the failure of a knuckle joint of a universal coupling system. Diameter d = 2d width a = o.75d eye: [4] studied non parametric shape optimization of knuckle joint for different materials using finite element analysis.
The Material Used For The Joint May Be Steel Or Wrought Iron [10].
The modification of one of the material that is changing cast iron into a composite polymer The material used for knuckle joint: They are widely used in tractor trailer, tie rod in roof truss, joint between the links of suspension bridge and
Mild Steel Or Wrought Iron.
Knuckle joint, all parts like fork end, knuckle pin, taper pin, collar and eye end used material is steel and wrought iron. S.g.iron or grey c.i has been used. The material used for the joint may be steel or wrought iron.
Post a Comment for "Material Used For Knuckle Joint"